What to do if the snap button is loose
Snaps button are hardware often used in clothing. After the snap is used for a long time, it will loosen, so what should I do? Below I will share with you the solution to the loose snap button.
After the snap button is loose, you can remove the original button and replace it with a spare button. The clothes will come with a spare button. The specific steps are as follows:
1. Prepare a complete set of copper rivet snap buttons. There are two buttons for each button, each of which is riveted by 2 small accessories.
2, choose the position of the lower rivet, it is best to make a mark. If you don't see the rivet from the outside, you need to cut the inner suture and install it from the inside.
3. After cutting a small hole with arrow scissors, put on a rivet with a hollow tip, and put on a complete set of accessories.
4. Insert a Phillips screwdriver into the hollow pointed tube, and tap the screwdriver with a hammer to allow the force on the screwdriver to be transmitted to the hollow pointed tube, so as to open and seal the opposite rivet.
5. Next, use the same method to install the opposite rivets in place, pay attention to find the position to be installed first.
6. It's finally done.
The above is the introduction of the solution to the loosening of the snap button. I hope that everyone will be helpful after understanding the solution of the loosening of the snap button.
